First, the features:
        The grinding machine is my factory independent research and development of new self-vacuuming grinding machine, the apheresis the Yu-steel welded, appearance, little vibration, easy adjustment. Widely used in the cement floor repair hi, ground old coatings and epoxy putty, also can be polished layer of epoxy mortar, epoxy mortar flatness.
        Second, the use
        A hard cement terrazzo floor, using a diamond disc (B) or (C) as a basis processing very loose cement floor or coated with glue flooring with silicon carbide grindstone (A) processing
        2> wiring remove the plug
        No. ① from the wall outlet and the plug inside two screws to open a crude Tongzhu zero line, the other three 80V FireWire, three FireWire connection, the zero line is not connected, the host can also work, mainline GB 4m2 inverted switch to self-vacuum high pressure blower switch, a large amount of dust out, the bottom metal box mounted dust off down smooth switch anti-open, let the fan reversal, the outlet side of the air intake when the outlet to reach clean up the inside of the filter dust blowback effect, promote the before and after every 10 minutes of the the cabinet middle of the white handles can clean up the effects of the filter dust. Vacuum box is divided into three fixed box in the middle, above the lid open you can come up with filter paper to clean up the following installed dust box necessary to clean up the dust in the box once every two hours.
        Third, repair and maintenance
        Work after a period of time, if not force, can loosen ③ No. chassis screws, adjust the ④ No. belts adjustment screw, if the belt is not loose, the motor rotates, but the chassis does not turn, may pulley loose, open cover board to re-install the pulley machine vibration check chassis rubber anti-vibration pad is off or broken if off plus gaskets do not be fastened if broken, please replace. Chassis below the triangular plate an angle not installed abrasive will create an imbalance, vibration occurs, please change the abrasive. Please a grindstone in the process of using tight with screws cards, so as not to hit flying out of the chassis work, please pay attention to safety.